Chat with Us On Whatsapp

+0141-4029001

[email protected]

Basic Building Parameters

Basic Building Parameters

Green Brick pre-engineered buildings are custom-designed to meet your exact requirements. The basic parameters that define a pre-engineered building are:

Building width is defined as the distance between the outer side of an eave strut of one side wall to the outer side of an eave strut of the opposite side wall.

This is defined as the distance between the outside 1langes of end wall columns in the opposite end walls and is a combination of several bay lengths.

End bay length is the distance from the outer side of the outer flange of endwall columns to centre line of the first interior frame column.

This is the distance between the centreline of two adjacent interior mainframe columns. The most Common Bay spacings are 6 mts, 7.5 mts and 9 mts. The bay lengths can go up to 15 mts.

Building height is the eave height, which is usually the distance from the bottom of the mainframe column base plate to the top outer point of the eave strut Eave height can go up to 30 mis. When columns are recessed or elevated from finished floor, eave height is the distance from finished floor to the top of the eave strut

This is the angle of the roof with respect to the horizontal base The most common roof slope is 1/10. However, any practical roof slope is possible.

Unless otherwise specified, Green Brick pre-engineered buildings aro designed for the following minimum loads:
Roof Live Load: 0.75 kN/m2
Design Wind Speed: As per IS:875 for location
Design for seismic loads, collateral loads or any other local conditions must be specified at the time of quotation.
Loads are applied in accordance with the latest American Codes and Standards applicable to pre-engineered buildings unless otherwise requested at the time of quotation

Copyright © 2019-20 Green Brick Project. All Right Reserved.